HE&M Saw H90A-4 Automatic Horizontal Pivot Bandsawing Machine

The Control Console is located in an Easy View style control on a gooseneck mount, and can be pivoted for operator convenience.

A standard 24" solid discharge table provides easier handling after the cut. The table is 24" in length and is fully coolant panned.

The automatic Bar-Feed on the saw is comprised of an air operated shuttle vise feed system with a zero to 24" four index feed stroke. The feed table includes a vertical alignment bar and mechanical readout.

On the part quantity counter, press the buttons to show the desired number of pieces to cut. The digital display will match the number put in and will count down with each piece cut.

The bar-feed will stroke the number of times the feed counter is set to, up to 4 indexes.

The saw vises slide on the vise ways. When the clamp is engaged, the air powered short stroking vise is pulled toward the fixed wear plate, clamping the material in place to ensure accurate cuts. The clamping pressure is easily adjusted to clamp various materials

Hold down fixtures also aid in the clamping of mul­tiple pieces of material in a single row.

The saw arm Feed Rate can be adjusted from zero to 3 inches per second.

Cutting force / pres­sure can be adjusted for effective metal removal rates.

Blade speed can be adjusted with an infinitely variable speed drive from the console with push button controls. The blade speed is shown on the console with LED Readout.

A blade guide system is composed of side and back guides, which are flat carbide inserts.

The Guide Arm is adjusted manually to help stabi­lize the blade and reduce vibration, providing a better cutting surface.

The Manual Blade Tensioner helps to keep the blade at the proper tension. It assures and main­tains proper blade tension at all times during the cutting process.

The patented Cut Watcher@ system monitors the cut for squareness to a pre-set deviation value. The system shuts down the saw when the pre-set value is exceeded. This is a must for production cutting.

A shaft-driven Blade Brush is standard for positive removal of metal chips that lodge in the blade gul­lets. This system ensures a cleaner blade, more accurate cuts, and prolonged blade life.

The saw is equipped with a safety Emergency Stop cut-off switch. This allows the operator to closely monitor the cutting process and quickly stop it if needed.

The Panic Stop haults all automatic functions.

The saw has a totally built-in coolant system with sealed coolant pump. The coolant is dispensed through the guide arms on both sides of the cut. A cutting fluid clean-up hose is provided for ma­chine wash down.

• 220V/440V/3PH Electrical Motor Requirement
• 85 PSI, 4-6 CFM Minimum Air Requirement (Equipped w/ Air Filter/Lubricator)

Reduced capacity top clamps can be added to the main or feed vise for vertical clamp­ing of structural shapes and when entire "mill bun­dles" are to be cut.

With the optional Interlocking Vise Jaws, the feed vise wear plate is extended and interlocks into a modified main vise wear plate on the forward feed stroke. This helps to reduce the remnant length during the final cut of the material. A 3rd Holding Vise on the Feed works in conjunc­tion with the main holding vise to assist in holding the material while it is being cut and also aids in aligning the material before it goes into the shuttle vise area.

The optional spray mist system lubricates the blade with a mist that is adjustable at a rate of 4 - 200 pulses per minute, pushing the mix of oil/air out of the delivery line to the nozzle.

5' or 1 0' optional idle roller tables with 12" centers are available for material handling. The tables are non-coolant panned and height adjustable to be
"trued-in" with the saw. They are designed to move even the large bars with ease and accuracy.